• Cyclone IV EP4CE115 with ~114,480 LEs
• 2 Gigabit Ethernet Ports, HSMC connector
• 128MB SDRAM, 2MB SRAM, 8MB Flash

• Develop and test PCI Express^® (PCIe^® ) 3.0 designs using the PCI-SIG^® -compliant development board.
• Develop and test memory subsystems consisting of DDR4, DDR3, QDR IV, and RLDRAM III memories.
• Develop modular and scalable designs by using the FPGA mezzanine card (FMC) connectors to interface to a FMC mezzanine card provided by Altera partners and supporting protocols, such as JESD204B,  Serial RapidIO^® , 10 Gbps Ethernet (10GbE), SONET, Common Public Radio Interface (CPRI),OBSAI, and many others.

• Terasic DE0-Nano-SoC Board
• Controlling through FPGA & HPS (ARM Processor) co-Design with higher flexibility than the MCU control system                                      
• Maximum of 24 PWM signal channels
• Bluetooth enable
• Open source

• Cyclone V SoC with Dual-core ARM Cortex-A9 (HPS)
• 1GB DDR3 SDRAM (32-bit data bus)(HPS)
• Arduino Expansion Header (Uno R3 Compatibility), UART-to-USB, USB OTG Port, Micro SD Card Socket, Gigabit  Ethernet and GPIO Headers

• Equipped with an 7-inch amorphous-TFT-LCD (Thin Film Transistor Liquid Crystal Display) module
• Module composed of LED backlight
• Supports 24-bit parallel RGB interface
• Converting the X/Y touch coordinates to corresponding digital data via Touch controller.

• Cyclone V 5CEBA4F23C7N Device
• 4-bit Resistor VGA
• Provides SPI and 4-bit SD mode for SD Card access
• Serial Configuration device – EPCS64
• 64MB SDRAM, x16 bits data bus
• On-Board USB Blaster (Normal type B USB)

• Arria V ST SoC—5ASTFD5K3F40I3NES (SoC)
• MAX^® V CPLD—5M2210ZF256C4N (system controller)
• MAX II CPLD—EPM570GF100 (embedded USB-Blaster^TM II cable)

• Cyclone V SoC with Dual-core ARM Cortex-A9 (HPS)
• 1GB DDR3 and 64MB SDRAM
• VGA Out, Video-In, UART-to-USB, USB Host x2, Micro SD Card Socket, 1Gbps Ethernet, and GPIO Headers

• Intel Stratix^® V GX FPGA (5SGXEA3K2F40C3)
• On-Board USB Blaster II or JTAG header for FPGA programming
• Fast passive parallel (FPPx32) configuration via MAX II CPLD and flash memory
• SSRAM, FLASH

• Altera Stratix^® V GX FPGA (5SGXEA7N2F45C2)
• Two SFP+ connectors, One Serial ATA (SATA II) host port
• DDR3 SDRAM, ISSI, FLASH

• Cyclone V SX SoC with Dual-core ARM Cortex-A9 (HPS)
• 2GB DDR3, 128MB QSPI Flash, EPCQ256
• SD-card, USB OTG, LCD, Ethernet, UART to USB, Transceiver, HSMC

• Cyclone V SX SoC—5CSXFC6D6F31C6N (SoC)
• 5-Megapixel Digital Image Sensor Module
• 7" LCD Touch Screen Module

• Cyclone V GX FPGA 5CGXFC7D6F31C7NES
• DDR3 SDRAM, flash 
• USB, Gigabit Ethernet, PCIe x4, HSMC, SDI, DVI I/O

• Arria V GX 5AGXFB3H4F35C5NES
• DDR3 SDRAM, SSRAM
• HDMI 1.3 TX, SDI 3G, Ethernet, DVI I/O

• Cyclone IV GXP4CGX150F31 device
• Intel^® Atom™ Dual Core Processor N2600( 1M Cache, 1.6GHz )
• Supports Windows & Linux Operation Systems

• Cyclone IV EP4CE115 with ~114,480 LEs
• 5-Megapixel Digital Image Sensor Module
• 7" LCD Touch Screen Module

• Please check our new VEEK-MT.
• Cyclone IV EP4CE115 with ~114,480 LEs
• 5-Megapixel Digital Image Sensor Module
• 8" LCD Touch Screen Module

• 256,000 logic elements (LEs)
• 102,600 adaptive logic modules (ALMs)
• 11,756 Kb on-chip memory

• Please check our new VEEK-MT.
• Cyclone IV EP4CE115 with ~114,480 LEs
• 5-Megapixel Digital Image Sensor Module
• 8" LCD Touch Screen Module

• Cyclone IV EP4CE115 with ~114,480 LEs
• 2 Gigabit Ethernet Ports, HSMC connector
• Supports CAN, RS-485, and RS-232 interfaces

• Arria II GX EP2AGX125 with transceivers
• 128MB DDR3 device, DDR2 SO-DIMM, 2MB SSRAM, 64MB FLASH
• Gigabit Ethernet, PCIe x8 Connector

• Stratix IV GX EP4SGX230/EP4SGX530 with transceivers
• PCIe x8 Connector and 2 DDR2 SO-DIMM
• High-Performance and Bandwidth Applications

• Stratix IV GX EP4SGX230KF40C2N FPGA
• DDR3 SDRAM, QDR II+ SRAM, flash, SSRAM
• PCIe x8, Gigabit Ethernet, HSMC, HDMI, 3G-SDI

• Cyclone IV GX EP4CGX15BF14C8N FPGA
• flash, SRAM
• PCIe x 1, Gigabit Ethernet

• Cyclone IV GX EP4CGX150N FPGA
• DDR2 SDRAM, SSRAM, flash
• PCIe x4, Gigabit Ethernet, HSMC

• Cyclone V E FPGA - 5CEFA7F31I7N
• DDR3 x32 at 300 MHz (soft memory controller)
• On-board USB-BlasterTM II cable (USB, PHY, Max® V CPLD)

• Please check our Cyclone V GT FPGA Development Kit
• DDR3, flash
• USB, Gigabit Ethernet, PCIe x4, HSMC, SDI

• Arria V GX 5AGXFB3H4F35C5NES
• HDMI 1.3 TX, SDI 3G, Ethernet
• DDR3 SDRAM, SSRAM

•  2 * Arria V GT FPGA 5AGTD7K3F40I3N
• DDR3 SDRAM, QDR II+ SRAM, flash
• HSMC, FMC, PCIe x8, SFP+, SDI

• 2 Stratix V GX FPGA 5SGXEA7N2F45C2N
• DDR3 SDRAM, QDR II+ SRAM, SRAM, flash
• PCIe x16, FMC connector, HSMC port

• Stratix V GT 5SGTMC7K3F40C2N
• Configuration flash
• 32 full-duplex GXB transceiver channels (up to 28.05 Gbps), Gigabit Ethernet

• Cyclone III EP3C16F484 with ~16,000 LEs
• 8MB SDRAM and 4MB Flash
• USB Blaster onboard

• Stratix III EP3SL150 F1152
• DDR2 SO-DIMM and USB Device/Host
• Large ASIC Prototyping Applications

• Cyclone II EP2C70F896 with ~70,000 LEs 
• 64MB SDRAM x2, 2MB SSRAM, and 8MB Flash
• Multimedia interface with dual TV decoder

• Cyclone II EP2C35F672 with ~35,000 LEs
• 8MB SDRAM, 512K SRAM, and 4MB Flash
• TV decoder, Ethernet, RS232, and USB Host/Device

• DE2-70 / DE2 / DE1 + LTM + D5M
• DE2 + DC2 +LCM

• Cyclone II EP2C20F484 with ~20,000 LEs
• 8MB SDRAM, 512K SRAM, and 4MB Flash
• Audio/Video interface, RS232, and SD card
• Also known as Cyclone II Starter Kit

• Cyclone III EP3C120F780 with ~120,000 LEs
• 256MB DDR2 SDRAM, 8 MB SSRAM, and 64MB Flash
• Gigabit Ethernet and Grapic LCD

• Cyclone III EP3C120F780 with ~120,000 LEs
• DDR2 SO-DIMM
• Support LVDS standard

• MAX II EPM2210F324C3
• Largest CPLD in MAX II series
• USB Blaster onboard 

• Stratix II EP2S180F1020 with ~180,000 LEs
• User IO with ~700 pins
• Compatible with TMA/TMB

• Replaced by DE1

• Cyclone III EP3C120F780 FPGA
• DDR2, SRAM, Flash
• Gigabit Ethernet, Graphics LCD, HSMC, USB

• Wi-Fi, using ESP-WROOM-02 module
• Bluetooth SPP, using HC-05 module
• 9-axis sensor: accelerometer,gyroscope,magnetometer
• Ambient light sensor
• Humidity and temperature sensor
• UART to USB
• 2x6 TMD GPIO Header 

• VEEK-MT-SoCKit Upgrade Kit
• IDE Cable with ITG Adapter
• MTL System CD-ROM
• 5V Power Supply
• Four Silicon Footstands

• Capacitive Multi-Touch LCD and Camera Module
• MTLC System CD-ROM

• 7" LCD, 800x480 Resolution,  24-bit Color
• Capacitive Touch, Multi-touch Gesture Support, Single Touch Support
• Compatible with DE2-115 / DE2 / DE3 /DE4

• Interfaces Aptina standard parallel socket with Altera HSMC connector
• Compatible with TR4

• RGMII Ethernet PHY, RJ-45 connector
• USB 2.0 OTG PHY with ULPI
• RS-485 x2 with 2x5 0.1* header
• CAN x2 with DB9 connector
• GPIO with 2x3 0.1* connector

• SATA Interface x2 plus ATA HD Power
• General Purpose XCVR (GP XCVR)
• Display Output for integrated National FPD2 Link (LVDS)
• General Display Output (LVDS)
• Camera Link Input (Base Configuration)
• MOST Network Interface for SMSC OS881110 evaluation board
• GPIO x 4

• 4.3” LCD Touch Panel with 800x480 resolution
• Multimedia interface, Ethernet, RS232, and SD card
• Embedded Processors Applications

• Micron 5 Mega Pixel CMOS sensor
• Video and Image Processing applications
• Compatible with DE series

• Support HSTC interface only
• HDMI transmitter & receiver port
• Video and Image Processing applications

• HSMC interface I/O to standard GPIO
• DE series boards to a HSMC host board
• Test points for signal measurement

TREX-S2 Motherboard Type B (TMB) is designed for application of DDRII/SDRAM/SRAM. Especially for verifying by DDRII Memory, users simply use our TMB to exempt from design the complicate schematic on their own.

• Compatibility: TREX-S2 Stratix II FPGA Modules

The reference design of TREX-S2 Motherboard Type A (TMA) is provided. Users can design their own motherboard by referencing the schematic and layout of our TMA.

• Compatibility: TREX-S2 Stratix II FPGA Modules

• IDC 2*20 Pin (Foolproof connector at both ends)
• Length: 30cm
• Compatibility: DC2 / LCM / LTM

• 800x480 resolution
• Support 24-bit parallel RGB interface
• Compatible with DE series

• Micron 1.3 Mega Pixel CMOS Sensor
• Video and Image Processing applications
• Compatible with DE series

• 320x240 resolution
• Signals of serial 8-bit (RGB or YUV)
• Compatible with DE series

• Santa Cruz interface supports 3.3V
• SD card slot
• Connectivity Applications

• HSMC interface
• Mictor Connector interface
• Connectivity Applications

• Input : AC 100~240V (50/60Hz)
• Output : DC 12V / 3.5A
• Size: 85.5*35.7*25.7mm
• Compatibility: DE1-SoC

• TREX-S2 Opener
• Color: White
• Compatibility: TREX-S2 Stratix II FPGA Prototyping System

• Material: Acrylic
• Size: L310*W200*T8 mm
• Compatibility: For  DE2-70 / DE2 to combine with 4.3" Ultra-high Resolution LCD Touch Panel , 5 Mega Pixel Digital Camera

• Material: Acrylic
• Size: L260.6*W200*T8 mm
• Compatibility: DE1 / Cyclone II Starter Kit to combine with 4.3" Ultra-high Resolution LCD Touch Panel  , 5 Mega Pixel Digital Camera