SIF User manual

From Terasic Wiki

(Difference between revisions)
Jump to: navigation, search
(Components)
(Components)
Line 29: Line 29:
=Components=
=Components=
This chapter will introduce the hardware components of the SIF-TMD card.
This chapter will introduce the hardware components of the SIF-TMD card.
 +
==USB to UART==

Revision as of 14:29, 12 July 2021

Overview

The SIF-TMD card can provide serail communication function (USB to UART) to the motherboard, users can connect this daughter card to FPGA motherboard which equipped Terasic TMD connector or GPIO connector (use jump wire) to get the UART protocal feature.User only need to connect the Host to the SIF-TMD card through the USB cable to establish the serail data transmision between the FPGA and the Host. In addition, the SIF-TMD also provides I2C interface EEPROM and SPI interface FLASH, allowing users to use FPGA to access these memories to realize the features of data access.


SIF-TMD 45 02.jpg

Board Featue :

  • USB to UART function
    • Emulate standard serial interface, used to upgrade the former peripheral device, or add excess serial interface through USB
    • Supports baud rate varies from 50bps to 2Mbps.
  • One I2C interface 32Kb EEPROM
  • One SPI Interface 8Mb Flash

The following two pictures show the board components of SIF-TMD:

  • Top View

SIF-TMD Top Layout.jpg

  • Botton View

SIF-TMD Bot Layout.jpg

The following picture shows the block diagram of the SIF-TMD card.

SIF-blockdiagram 01.jpg

Components

This chapter will introduce the hardware components of the SIF-TMD card.

USB to UART

Personal tools