From Terasic Wiki
(Difference between revisions)
|
|
| Line 8: |
Line 8: |
| | b.请注意FPGA主板的jtag链回环。如果没有接子卡 ， 注意开发板上的对应跳线帽接法，让jtag链形成回环。 | | b.请注意FPGA主板的jtag链回环。如果没有接子卡 ， 注意开发板上的对应跳线帽接法，让jtag链形成回环。 |
| | c.查看Programmer的Mode 设置是否正确。（请设置到jtag mode） | | c.查看Programmer的Mode 设置是否正确。（请设置到jtag mode） |
| - |
| |
| - |
| |
| - | #Plug the USB-Blaster II cable into your PC.
| |
| - | #Open the '''Device Manager''', and right-click on the '''Unknown device''' under the '''Other devices''' branch.
| |
| - | #Select '''Update Driver Software'''.
| |
| - | #elect '''Browse my computer for driver software'''.
| |
| - | #Enter the location of the Quartus Prime software USB-Blaster II driver files directory ('''<Path to Quartus Prime installation>\drivers\usb-blaster-ii''') in the '''Search for driver software in this location''' field.
| |
| - | #Click '''Next'''.
| |
| - | #Click '''Install''' in the '''Would you like to install this device software'''? Windows security dialog box.
| |
| - | #Close the '''Update Driver Software - Altera USB-Blaster II (Unconfigured)'''successful installation notification. The Device Manager now shows a new branch called '''JTAG cables''' with an '''Altera USB-#Blaster II (Unconfigured)''' node.
| |
| - | #Open the Quartus Prime Programmer. Within a few seconds, the '''JTAG cables''' branch displays two nodes: '''Altera USB-Blaster II (JTAG interface)''' and '''Altera-USB Blaster II (System Console interface)'''.
| |
| - |
| |
| - | [[Terasic_USB_Blaster_Document|Back]]
| |
Revision as of 18:00, 14 April 2017
Can't download .sof file
- Programmer找不到端口导致.sof文件无法下载
解决办法link 到《Programmer检测不到USB Blaster》网页。
- Programmer找得到端口，但是下载到一定进度显示失败：
a. 查看RUN/PROG开关的设置是否正确。（请设置到RUN 模式）
b.请注意FPGA主板的jtag链回环。如果没有接子卡 ， 注意开发板上的对应跳线帽接法，让jtag链形成回环。
c.查看Programmer的Mode 设置是否正确。（请设置到jtag mode）
