DE10-Agilex Board Revision Document

From Terasic Wiki

Revision as of 14:29, 26 February 2021 by Admin (Talk | contribs)
Jump to: navigation, search

How to Find the DE10-Aiglex Board Revision?

On the bottom view of the PCB, there is a seal mark for the board hardware version.


As shown in the figure below, if the letter inside the red circle is "B", it means that the PCB version is Rev.B.

DE10 Agilex board version 01.jpg

Board Revision Details

Rev. A to Rev. B

  1. Add Force External Power Switch (SW1) to Enable/Disable External Power Requirement when connected to the HOST PC.
    De ag sw1.jpg
  2. Add System MAX10 Jtag bypass switch (SW9) for increase JTAG sacn speed.
    De ag sw9.jpg
  3. Modify the direction of the external power connector.
    De ag ex pwr.jpg
  4. Remove DDR4 Clock Source Switch (SW5) and change the DDR4 source clock oscillator (Y2) from dual clock OSC (166.667/300.0MHz) to 33.333Mhz OSC.
    De ag ddr4 clock osc.jpg
Retrieved from "http://www.terasic.com.tw/wiki/DE10-Agilex_Board_Revision_Document"