Intel USB Blaster Driver Installation Instructions
From Terasic Wiki
(Difference between revisions)
| Line 12: | Line 12: | ||
#The Device Manager now shows a new branch called '''Universal Serial Bus controllers''' with an '''Altera USB-Blaster II (JTAG interface)''' node. | #The Device Manager now shows a new branch called '''Universal Serial Bus controllers''' with an '''Altera USB-Blaster II (JTAG interface)''' node. | ||
#:[[File:Ubt driver 05.jpg]] | #:[[File:Ubt driver 05.jpg]] | ||
| - | #Open the Quartus Prime Programmer. Within a few seconds, the '''''' | + | #Open the Quartus Prime Programmer. Within a few seconds, you may see right side of the '''Hardware Setup''' should display "USB-Blaster[USB-x]". If not, please click "Hardware Setup" and select the Available hardware items, then click clouse. |
| + | #:[[File:Ubt driver 06.jpg|500px]] | ||
Revision as of 11:15, 19 August 2022
- Make sure the USB blaster connector of the development board and your Host PC is connected with USB cable(Also the board is power up).
- Open the Device Manager, and right-click on the USB-Blaster under the Other devices branch.
- Select Update Driver Software.
- Select Browse my computer for driver software.
- Enter the location of the Quartus software USB-Blaster driver files directory (<Path to Quartus Prime installation>\drivers\usb-blaster) in the Search for driver software in this location field.
- Click Next.
- Close the Update Driver Software - Altera USB-Blaster successful installation notification.
- The Device Manager now shows a new branch called Universal Serial Bus controllers with an Altera USB-Blaster II (JTAG interface) node.
- Open the Quartus Prime Programmer. Within a few seconds, you may see right side of the Hardware Setup should display "USB-Blaster[USB-x]". If not, please click "Hardware Setup" and select the Available hardware items, then click clouse.
