SIF User manual
From Terasic Wiki
(→USB to UART Inteface) |
(→USB to UART Inteface) |
||
Line 29: | Line 29: | ||
=Components= | =Components= | ||
This chapter will introduce the hardware components of the SIF-TMD card. | This chapter will introduce the hardware components of the SIF-TMD card. | ||
- | ==USB to UART | + | ==USB to UART Interface== |
- | The UART serial interface is designed to perform communication between the board and the PC. he physical interface is done using UART-USB on-board bridge from a CH340E chip and connects to the host using a Mini-USB connector.The CH340E on the SIF-TMD card wouldn’t support HW flow control signals and | + | The UART serial interface is designed to perform communication between the board and the PC. he physical interface is done using UART-USB on-board bridge from a CH340E chip and connects to the host using a Mini-USB connector. The CH340E on the SIF-TMD card wouldn’t support HW flow control signals and it provides TXD and RXD signals to the TMD connector on the SIF-TMD card. Also the chip supports communication baud rate varies from 50bps to 2Mbps. For detailed information and host driver for the CH340E chip, please refer to the datasheet, which is available on the [http://www.wch-ic.com/downloads/CH340DS1_PDF.html manufacturer’s website]. |
Revision as of 15:30, 12 July 2021
Overview
The SIF-TMD card can provide serail communication function (USB to UART) to the motherboard, users can connect this daughter card to FPGA motherboard which equipped Terasic TMD connector or GPIO connector (use jump wire) to get the UART protocal feature.User only need to connect the Host to the SIF-TMD card through the USB cable to establish the serail data transmision between the FPGA and the Host. In addition, the SIF-TMD also provides I2C interface EEPROM and SPI interface FLASH, allowing users to use FPGA to access these memories to realize the features of data access.
Board Featue :
- USB to UART function
- Emulate standard serial interface, used to upgrade the former peripheral device, or add excess serial interface through USB
- Supports baud rate varies from 50bps to 2Mbps.
- One I2C interface 32Kb EEPROM
- One SPI Interface 8Mb Flash
The following two pictures show the board components of SIF-TMD:
- Top View
- Botton View
The following picture shows the block diagram of the SIF-TMD card.
Components
This chapter will introduce the hardware components of the SIF-TMD card.
USB to UART Interface
The UART serial interface is designed to perform communication between the board and the PC. he physical interface is done using UART-USB on-board bridge from a CH340E chip and connects to the host using a Mini-USB connector. The CH340E on the SIF-TMD card wouldn’t support HW flow control signals and it provides TXD and RXD signals to the TMD connector on the SIF-TMD card. Also the chip supports communication baud rate varies from 50bps to 2Mbps. For detailed information and host driver for the CH340E chip, please refer to the datasheet, which is available on the manufacturer’s website.