The CP2102N (USB to UART) Driver Installation Instructions
From Terasic Wiki
(Difference between revisions)
Line 8: | Line 8: | ||
#:Using USB cable to connect your CP2102 chip board to host PC. | #:Using USB cable to connect your CP2102 chip board to host PC. | ||
#Detect Your Device | #Detect Your Device | ||
- | #:The CP2102N device will appear as a COM port in Device Manager in Windows. | + | ##IF your host had never installed the driver of the The CP2102N device, the Device Manager of your host will appear a "CP2102N USB to UART Bridge Controller" device. |
+ | ##:[[File:Cp2102n a.jpg|300px]] | ||
+ | ##: | ||
+ | ##:Please install the downloaded driver as described in setp1. | ||
+ | ##: | ||
+ | ##:[[File:Cp2102n b.jpg|400px]] | ||
+ | ##:After the driver is installed, The CP2102N device will appear as a COM port in Device Manager in Windows as shown in below. '''Please note that the COM Port number is different in different host PC.''' | ||
+ | ##:[[File:Cp2102n c.jpg|400px]] |
Revision as of 13:43, 12 November 2021
This guide will show you how to install the Virtual COM Port (VCP) Drivers for the Silicon lab's USB to UART chip(CP2102N).
- Download the driver
- Download and Install the Latest Virtual COM Port (VCP) Drivers.
- The Virtual COM Port (VCP) drivers enable the CP2102N to appear as a standard COM port. Download the latest version of drivers
- from the Silicon Labs website: https://www.silabs.com/developers/usb-to-uart-bridge-vcp-drivers
- Establish the USB connection
- Using USB cable to connect your CP2102 chip board to host PC.
- Detect Your Device
- IF your host had never installed the driver of the The CP2102N device, the Device Manager of your host will appear a "CP2102N USB to UART Bridge Controller" device.