USB Blaster Self Test

From Terasic Wiki

Revision as of 13:46, 7 April 2017

This document describes users how to test whether the on-board USB blaster or USB blaster cable is properly installed and operated.

1. Power on the FPGA board and connect USB blaster port or USB blaster cable to PC.
   Check if the Universal Serial Bus controllers in the Windows Device Manager has an Altera USB Blaster.
   If yes, users can use Quartus programmer and download FPGA code.
   
   
   
2. If Altera USB Blaster isn’t showed in Universal Serial Bus controllers, please check whether the Other devices has Unknown device.
   If yes, please install the USB blaster driver refer to this link:Altera USB Blaster Driver Installation Instructions
   .
   
   
3. If no Unknown device:

i.Make sure the board power is on and the port on board which connected to PC is USB blaster port.

ii.If step i is OK:

a.Test with another PC to see if the OS can detect unknown device.

b.Test with another usb blaster cable.

c.If still with the same problem, please contact our technical support team via support@terasic.com and provide below information:

• PC OS version: Win10-32bit or Win7-64bit or Linux-64bit.
• Whether you tested follow the above processes.
• The Quartus version you in stalled: Q16.1 or others.