DE10-Nano Kit

DE10-Nano Kit

The DE10-Nano board has many features that allow users to implement a wide range of designed circuits, from simple circuits to various multimedia projects.

The following hardware is provided on the board:

FPGA Device

  • Intel Cyclone® V SE 5CSEBA6U23I7  device (110K LEs)
  • Serial configuration device  – EPCS64 (revision B2 or later)
  • USB-Blaster II onboard for programming; JTAG Mode
  • HDMI TX, compatible with DVI 1.0 and HDCP v1.4
  • 2 push-buttons
  • 4 slide switches
  • 8 green user LEDs
  • Three 50MHz clock sources from the clock generator
  • Two 40-pin expansion headers
  • One Arduino expansion header (Uno R3 compatibility), can be connected with Arduino shields
  • One 10-pin Analog input expansion header (shared with Arduino Analog input)
  • A/D converter, 4-pin SPI interface with FPGA

* If the specification of memory device in Quick Start Guide and official website is discordant, refer to DE10-Nano website as the sole stardard.

HPS (Hard Processor System)

  • 800MHz Dual-core ARM Cortex-A9 processor
  • 1GB DDR3 SDRAM (32-bit data bus)
  • 1 Gigabit Ethernet PHY with RJ45 connector
  • USB OTG Port, USB Micro-AB connector
  • Micro SD card socket
  • Accelerometer (I2C interface + interrupt)
  • UART to USB, USB Mini-B connector
  • Warm reset button and cold reset button
  • One user button and one user LED
  • LTC 2x7 expansion header

Block Diagram of the DE10-Nano Board

 

Connectivity

  • Connect Arduino


 

  • Connect LTC2607 (AD/DA Daugher Card)

 

Overview
Layout