DE10-Advance Hardware Manual revC Chapter3 Board Setting Headers

==3.2 Board Setting Headers==
==JTAG Interface Header==

J17 is the header used to set the JTAG bus of FMC connector connect to JTAG interface of DE10-Advanced system.The FMC connector will not be included in the JTAG chain if the headers are set to open(See Figure 3-3). Table 3-2 list the setting of the J17 header.<br/>



::::::::'''Table 3-2 JTAG Interface Headers Setting'''
:{| class="wikitable"
  |-
!Header	!!Setting	!!Descriptions	
|-
|J17	||Open (Default Setting)||Disable the JTAG interface of the FMC connector into the JTAG chain
|}



[[File:De10-advanced revc fmc jtag.jpg|500px]]
:::::::'''Figure 3-3 The FMC Jtag Header'''


==FMC_VCCIO Select Header==

JP2 is used to set the VCCIO voltage of FPGA I/O on FMC connector, as1.2V/1.5V/1.8V are supported, the FMC connector can support various I/0 standard FMC daughtercards. Table 3-3 list the FMC_VCCIO Headers Setting.

::'''Table 3-3  FMC_VCCIO Headers Setting'''
:{| class="wikitable"
  |-
!JP2 Setting	!!FMC VCCIO Voltage
|-
|[[File:De10-advanced revc fmc viccio 12.jpg|100px]]||1.2V
|-
|[[File:De10-advanced revc fmc viccio 15.jpg|100px]]||1.5V
|-
|[[File:De10-advanced revc fmc viccio 18.jpg|100px]]||1.8V(Default Setting)
|}

[[File:De10-advanced revc fmc vccio header.jpg|500px]]

:::::::'''Figure 3-4 The FMC VCCIO select header'''


==PMODE Select Header==

The USB 3.0 Controller (Cypress FX3) on the DE10-Advanced can be booted from a different sources, selected by the configuration of the PMODE header(JP4/JP5/JP6) on DE10-Advanced. Table 3-4 shows the boot options and associated settings. The default boot device is the from an serial flash via SPI interface.  


::::'''Table 3-4  PMODE Headers Setting'''
:{| class="wikitable"
  |-
!PMODE[2:0](JP6/JP5/JP4) Setting	!!Boot Source
|-
|F00||Sync ADMux (16-bit)
|-
|F01||Async ADMux (16-bit)
|-
|F11||USB boot
|-
|F0F||Async SRAM (16-bit)
|-
|F1F||I2C, On Failure, USB Boot is Enabled
|-
|1FF||I2C only
|-
|0F1(Defualt)||SPI, On Failure, USB Boot is Enabled
|}

:*'''F''' indicates Floating



[[File:De10-advanced revc pmode.jpg|500px]]

:::::::'''Figure 3-5 The PMODE select header'''


[[DE10-Advance Hardware Manual revC Chapter3|'''Back''']]