Full Mode

From Terasic Wiki

(Difference between revisions)
Jump to: navigation, search
(Created page with "! ''' How to make CLR daughter card to support the full mode '''<br/> # First of all, there are some of the ICs on board, such as U4 U5 RN4, need to be removed. Because they are...")
 
(3 intermediate revisions not shown)
Line 1: Line 1:
-
! ''' How to make CLR daughter card to support the full mode '''<br/>  
+
''' How to make CLR daughter card to support the full mode '''<br/>  
-
# First of all, there are some of the ICs on board, such as U4 U5 RN4, need to be removed. Because they are used for supporting the Base 2 mode controlling, and they take the bus of the ICs for supporting the full mode.  
+
* First of all, there are some of the ICs on board, such as U4 U5 RN4, need to be removed. Because they are used for supporting the Base 2 mode controlling, and they take the bus of the ICs for supporting the full mode.  
-
 
+
-
Second, equip some neccessary ICs into the board for the full mode:
+
 +
* Second, equip some neccessary ICs into the board for the full mode:
[[File:CLR_FULL.png]]
[[File:CLR_FULL.png]]
 +
 +
: We do make the modification onto the CLR-HSMC card for the full mode support for another customer either. And it works in Full mode with 8 Taps (8x8bits) with good stability. It works well with the MC3010 high speed camera at the data rate of 680MB/s. But this card cannot support full CameraLink with 10 Taps (10x8bits). Because there are not enough pins on the HSMC port of the CLR_HSMC card to support 10 Taps (16 additional IO pins needed).

Latest revision as of 17:08, 17 April 2017

How to make CLR daughter card to support the full mode

  • First of all, there are some of the ICs on board, such as U4 U5 RN4, need to be removed. Because they are used for supporting the Base 2 mode controlling, and they take the bus of the ICs for supporting the full mode.
  • Second, equip some neccessary ICs into the board for the full mode:

CLR FULL.png

We do make the modification onto the CLR-HSMC card for the full mode support for another customer either. And it works in Full mode with 8 Taps (8x8bits) with good stability. It works well with the MC3010 high speed camera at the data rate of 680MB/s. But this card cannot support full CameraLink with 10 Taps (10x8bits). Because there are not enough pins on the HSMC port of the CLR_HSMC card to support 10 Taps (16 additional IO pins needed).
Personal tools