DE10-Advance Hardware Manual revC Chapter3 Board Status LED

From Terasic Wiki

Contents 1 3.3 Status LED 2 UART Interface 3 SFP Interface 4 Ethernet Interface 5 Power 6 USB Blaster

3.3 Status LED

This section describes the all status LED for the interfaces on DE10-Advanced board. Figure 3-6 shows all the status LED on the DE10-advanced. Following are the detailed descriptions of these interface LED.

Figure 3-6 The status LED on the DE10-Advanced board

UART Interface

Table 3-5 list the two status LEDs for UART interface.

Table 3-5 Status LED for UART Interface

Component	Reference	Status	Descriptions
TXD1	UART_TXD	ON	Transmitting
RXD1	UART_ＲXD	ON	Receiving

SFP Interface

Table 3-6 list the four status LEDs for SFP interface.

Table 3-6 Indicator LED for SFP Interface

Component	Reference	Status	Descriptions
D4	SFPA_MOD0_PRSNT_n	ON	Indicate that the SFP module is present on the SFPA
D3	SFPB_MOD0_PRSNT_n	ON	Indicate that the SFP module is present on the SFPB
D2	SFPC_MOD0_PRSNT_n	ON	Indicate that the SFP module is present on the SFPC
D1	SFPD_MOD0_PRSNT_n	ON	Indicate that the SFP module is present on the SFPD

Ethernet Interface

Table 3-7 list the four status LEDs for Ethernet interface.

Table 3-7 Status LED for Ethernet Interface

Component	Reference	Status	Descriptions
D8	ETH_LED_TX	ON	Transmitting
D9	ETH_LED_RX	ON	Receiving
D10	ETH_LINK1000	ON	1000Mbps Link UP
D11	ETH_LINK100	ON	100Mbps Link UP

Power

Table 3-8 list the two status LEDs for power.

Table 3-8 Status LED for Power

Component	Reference	Status	Descriptions
D31	12V~20V Power Indicator	ON	Illuminates when 12V~20V power Power Supply is active

USB Blaster

Table 3-6 list the two status LEDs for USB Blaster interface.

Table 3-5 Status LED for USB Blaster Interface

Component	Reference	Status	Descriptions
D5	JTAG_TX	ON	Illuminates when JTAG interface is transmitting data
D6	JTAG_RX	ON	Illuminates when JTAG interface is receiving data

[DE10-Advance Hardware Manual revC Chapter3|Back]]