DE10 Advance Board Setup: MSEL Settings
From Terasic Wiki
(Difference between revisions)
(→AS Mode) |
|||
| Line 9: | Line 9: | ||
When the board is powered on and MSEL [2:0] is set to “010” (See Figure 2-2), the FPGA is configured from EPCQ. | When the board is powered on and MSEL [2:0] is set to “010” (See Figure 2-2), the FPGA is configured from EPCQ. | ||
| - | + | :::[[File:De10-advanced revc msel asmode.jpg|500px]] | |
| - | ::::Figure 2-2 FPGA Configuration Mode Switch set in AS Mode | + | ::::::Figure 2-2 FPGA Configuration Mode Switch set in AS Mode |
'''[[DE10-Advance Getting Start Guide revC#Chapter 2 Development Board Setup|Back]]''' | '''[[DE10-Advance Getting Start Guide revC#Chapter 2 Development Board Setup|Back]]''' | ||
Revision as of 15:35, 30 August 2018
FPPx32 Mode (Default)
The FPGA Configuration Mode Switch (MSEL) shown in Figure 2-1 is by default set to 001 (MSEL [2:0] = 001). The setting corresponds to FPGA configured from HPS software (in the SD Card) in FPP mode. If users want to boot with Linux VNC desktop, please setting MSEL switch in this mode.
- Figure 2-1 FPGA Configuration Mode Switch set in FPPx32 Mode (TBD)
AS Mode
When the board is powered on and MSEL [2:0] is set to “010” (See Figure 2-2), the FPGA is configured from EPCQ.
- Figure 2-2 FPGA Configuration Mode Switch set in AS Mode
