From Terasic Wiki

Contents 1 Chapter 1 About this guide 2 Chapter 2 Development Board Setup 3 Chapter 3 Software Installation 4 Chapter 4 Performing a FPGA System Test 5 Chapter 5 Running Linux on the DE10-Advanced board via UART Terminal

Chapter 1 About this guide

The DE10-Advanced Getting Started Guide contains a quick overview of the hardware and software setup including step-by-step procedures from installing the necessary software tools to using the DE10-Advanced board. The main topics in this guide covers are listed below:

• Development Board Setup: Powering on the DE10-Advanced
• Software Installation: Installing Quartus Prime and SoC EDS
• Perform a FPGA System Test: Downloading a FPGA SRAM Object File (.sof)
• Running Linux on DE10- Advanced board via UART terminal

Chapter 2 Development Board Setup

• 2.1 Introduction
• 2.2 MSEL Settings
• 2.3 USB , Ethernet Port and Power Cables
• 2.4 Power up the DE10-Advanced Board with LXDE VNC Desktop Environment

Chapter 3 Software Installation

• 3.1 Introduction
• 3.2 Installing Quartus Prime software
• 3.3 Installing Intel SoC Embedded Design Suite

Chapter 4 Performing a FPGA System Test

• 4.1 Introduction
• 4.2 Installing the USB-Blaster II Driver
• 4.3 Downloading a FPGA SRAM Object File

Chapter 5 Running Linux on the DE10-Advanced board via UART Terminal

• 5.1 Introduction
• 5.2 Setting Up UART Terminal
• 5.3 Running Linux on DE10-Advanced board
• 5.4 Creating a MicroSD Card Image