DE10 Advance Running Linux via UART Terminal: Running Linux on DE10-Advanced board

From Terasic Wiki

Jump to: navigation, search

This section presents how to run the pre-built Linux images on the DE10-Advanced board. You can run the Linux by following the steps below:

  • Insert the factory microSD card with the pre-built image into the board (See Section 5.4 to prepare a microSD card)
  • Make sure the MSEL switch is set to “MSEL [2:0] = 001”
  • Power up the board (See Chapter 2 for details)
  • Open putty.exe, select the saved configuration de10_Advanced and click open button.
  • After the board is successfully booted, the Linux will ask for the login name. Type "root" and press the Enter key to skip the password, as shown in Figure 5-5.
Putty Window 2.jpg
Figure 5-5 Putty Window

Back

Retrieved from "http://www.terasic.com.tw/wiki/DE10_Advance_Running_Linux_via_UART_Terminal:_Running_Linux_on_DE10-Advanced_board"
Personal tools