DE10 Advance Board Setup: MSEL Settings
From Terasic Wiki
(Difference between revisions)
(→AS Mode) |
(→FPPx32 Mode (Default)) |
||
Line 2: | Line 2: | ||
The FPGA Configuration Mode Switch (MSEL) shown in Figure 2-1 is by default set to 001 (MSEL [2:0] = 001). The setting corresponds to FPGA configured from HPS software (in the SD Card) in FPP mode. '''If users want to boot with Linux VNC desktop, please setting MSEL switch in this mode'''. | The FPGA Configuration Mode Switch (MSEL) shown in Figure 2-1 is by default set to 001 (MSEL [2:0] = 001). The setting corresponds to FPGA configured from HPS software (in the SD Card) in FPP mode. '''If users want to boot with Linux VNC desktop, please setting MSEL switch in this mode'''. | ||
- | + | :::[[File:De10-advanced revc msel fppmode.jpg|500px]] | |
- | ::::Figure 2-1 FPGA Configuration Mode Switch set in FPPx32 Mode | + | :::::Figure 2-1 FPGA Configuration Mode Switch set in FPPx32 Mode |
- | + | ||
=AS Mode= | =AS Mode= |
Latest revision as of 16:08, 30 August 2018
FPPx32 Mode (Default)
The FPGA Configuration Mode Switch (MSEL) shown in Figure 2-1 is by default set to 001 (MSEL [2:0] = 001). The setting corresponds to FPGA configured from HPS software (in the SD Card) in FPP mode. If users want to boot with Linux VNC desktop, please setting MSEL switch in this mode.
AS Mode
When the board is powered on and MSEL [2:0] is set to “010” (See Figure 2-2), the FPGA is configured from EPCQ.