- Cyclone V SoC with Dual-core ARM Cortex-A9 (HPS)
- 1GB DDR3 SDRAM (32-bit data bus) (HPS)
- Arduino Expansion Header (Uno R3 Compatibility), Full HD HDMI Output, UART-to-USB, USB OTG Port, Micro SD Card Socket, Gigabit Ethernet and GPIO Headers
- Intel Cyclone V SoC FPGA，ARM Cortex-A9 雙核 HPS
- FPGA：SDRAM、VGA 輸出、Video 輸入、ADC 接頭、GPIO 接頭、HSMC 接頭
- HPS：DDR3、USB Host 埠、MicroSD 卡槽、乙太網、UART 轉 USB、LTC 接頭
- 支持 Linux BSP 和 openCL BSP
- MAX 10 10M50DAF484C7G Device
- Accelerometer and 4-bit Resistor VGA
- 64MB SDRAM, x16 bits data bus
- Arduino UNO R3 and 2x20 GPIO connector
- On-Board USB Blaster (Normal type B USB)
- Drive up to 24 servo motors simultaneously
- MG996R Servo Motor is included
- Open source example is provided
- 2.4" LCD touch module with 240(H) x 320 (V) pixel resolution LCD with 65K RGB color
- Single resistive touch
- 2x20 GPIO interface
- Intel Stratix 10 GX/SX FPGA
- Four QSFP28(100GbE) connectors and one PCI Express (PCIe) x16 edge connector
- Four independent DDR4 SODIMM sockets (work with DDR4/QDR-II+/QDR-IV)
- Omnivision 8 Mega Pixel Image sensor
- Voice Coil Motor (VCM) for focus control
- MIPI Decoder
- 2x20 GPIO to compatible with DE series FPGA Board
- 7" LCD, 800x480 Resolution, 24-bit Color
- Capacitive Touch, Multi-Touch Gesture Support, Single Touch Support
- 2x20 GPIO Interface, Compatible with DE2-115 / DE2 / DE3 /DE4
- Configurable digital interface to a processor—RF front end with a flexible mixed-signal baseband section and integrated frequency synthesizers
- Operates in the 70 MHz to 6.0 GHz range—covers most licensed and unlicensed bands
- Tunable Channel Bandwidth—<200 kHz to 56 MHz
- Complete dual- or single-channel integrated wideband transceiver on a single chip
- Wi-Fi, using ESP-WROOM-02 module
- Bluetooth SPP, using HC-05 module
- 9-axis sensor: accelerometer,gyroscope,magnetometer
- Ambient light sensor
- Humidity and temperature sensor
- UART to USB
- 2x6 TMD GPIO Header
- Intel® Agilex™ F-Series FPGA AGFB014R24B2E2V
- Two QSFPDD connectors for 200/100/40/25/10 GbE network interface
- Four independent DDR4 SODIMM sockets
- PCIe Gen4 x16
As the pioneering FPGA-based product and design service supplier, Terasic never stops looking for innovating and cutting-edge ideas! This time, we challenge you to conduct a technical review and provide ideas that will ignite sparks of creativity for our flagship product, DE10-Standard. All users of Terasic FPGA board are welcome to participate in this event!
- Bluetooth v 4.0+EDR
- Class 1, wireless range of up to 50m
- Compliant to DE10-Standard and DE10-Nano Linux BSP
- The cable is 20 cm long.
- Turn your DE10-Nano into a USB host via the OTG port onboard.
- Allow you to connect USB accessories such as Flash drive, keyboard, mouse, camera, Bluetooth or Wi-Fi module to your DE10-Nano .
The DE10-Pro 2-slot passive heatheak allows users to purchase and change to DE10-Pro board to provide better heat dissipation.