The HAN Pilot Platform has many features that allow users to implement a wide range of high performance designed circuits.The following hardware is provided on the board:

FPGA Device

• Intel ^® Arria10^® SoC 10AS066K3F40E2SG device (660K LEs)
• USB-Blaster II onboard for programming; JTAG Mode
• Serial configuration device – EPCQL1024
• One DDR4 SO-DIMM Socket, support ECC
• On-board 1GB DDR4-2400, 32-bit data width
• USB Type-C Interface
  • Power Delivery
  • DisplayPort TX with 4 lanes
  • USB 3.0/2.0
• HDMI TX/RX 2.0 for 4K2K@60- FPGA Transceiver
• PCIe Cabling Socket at Gen3 x4
• SFP+ Socket x4, 40Gbps
• SATA 3.0 Host and SATA Device x2 (SATA Connector x4)
• One Gigabit Ethernet Port
• SMA Clock-In and Clock-Out
• High Pin Count FMC Connector. Support VADJ 1.2V/1.5V/1.8V.
• Accelerometer, Gyroscope and Magnetometer
• Temperature Sensor
• Fan Control
• LED x2, KEY x2, Switch x2, 7-Segment x2

HPS (Hard Processor System)

• 1.5GHz Dual-core ARM Cortex-A9 processor
• MicroSD Socket
• On-board 1GB DDR4-2400, 32-bit data width
• 1 Gigabit Ethernet PHY with RJ45 connector
• USB OTG Port, USB mini-AB connector
• UART to USB, USB Mini-B connector
• RTC
• One user button and one user LED
• Warm reset button and cold reset button

Block Diagram:

Memory Sockets

In addition to DDR4 Sodimm, it also compatible with Terasic QDRII+ Memory Module.

• DDR4 Sodimm Memory Module Installed

 

• QDRII+ Memory Module Installed

• QDRII+ SODIMM Module
  • Total 144Mb(18MB) for two chips
  • 36-bit data width
  • 550 MHz

FMC Connectivity

• Connect XTS-FMC

 

• Connect D8M-FMC

 

• Connect 12G SDI-FMC

 

• Connect HDMI-FMC

 

• Connect TI JESD Board