• Ideal for use with embedded soft processors
• Tiny and robust packaging for portable applications
• Expansion headers for daughter cards, motors, actuators, etc.

• Support HSMC or GPIO interface
• Two 14-bit AD/DA converters
• DSP Applications

• Cyclone III EP3C16F484 with ~16,000 LEs
• 8MB SDRAM and 4MB Flash
• USB Blaster onboard

• Cyclone V SoC with Dual-core ARM Cortex-A9 (HPS)
• 1GB DDR3 SDRAM (32-bit data bus)(HPS)
• Arduino Expansion Header (Uno R3 Compatibility), UART-to-USB, USB OTG Port, Micro SD Card Socket, Gigabit  Ethernet and GPIO Headers

• Cyclone V 5CEBA4F23C7N Device
• 4-bit Resistor VGA
• Provides SPI and 4-bit SD mode for SD Card access
• Serial Configuration device – EPCS64
• 64MB SDRAM, x16 bits data bus
• On-Board USB Blaster (Normal type B USB)

• Terasic DE0-Nano-SoC Board
• Controlling through FPGA & HPS (ARM Processor) co-Design with higher flexibility than the MCU control system                                      
• Maximum of 24 PWM signal channels
• Bluetooth enable
• Open source

In collaboration with Altera’s University Program, Terasic Technologies has announced the release of Altera’s newest University Program FPGA development board, the DE0-Nano. Measuring just 49 mm by 75.2 mm and weighing about 40 grams, the DE0-Nano board is well-suited to a wide range of portable design projects, such as robotics applications.

• Input:5V
• Size: L80*W36*T10 mm
• Compatibility:DE0 / DE1 / DE2 / DE2 -115

• 250V / 5A
• Convenient way to switch from US wall plugs to UK wall plugs
• Simple snap-on design used with Terasic Technologies's switching power supplies
• Compatibility: DE10-Nano / DE0 / DE2-115 / C5G / DE1-SoC  

Since Terasic was established in 2003, the number one priority of the board-design company has always been to revolutionize the educational landscape of digital logic design by taking laboratory and on-hands training to the next level. With the release of the Development and Education (DE) Series, ranging from the tiny Cyclone DE0-Nano development board to high-end Stratix DE5-Net development board, the DE series includes an impressive feature-set that satisfies virtually every educational requirement. Unlike prior kits, the release of the DE boards heavily emphasized real-world applications, taking laboratory classes beyond just operating LEDs and switches and into practical development with multimedia, industrial communication, and networking.

• 7.5VDC switching supply with 0.8A current
• Output: AC 100~240V (50/60Hz)
• Input: DC 7.5V/0.8A
• Size: 44*32*23.5 mm
• Compatibility:  DE0 / DE1 / Cyclone II Starter Kit  

  The DE10-Pro 2-slot passive heatheak allows users to purchase and change to DE10-Pro board to provide better heat dissipation.